Following the link below you can download the most recent version of the software for use with either the IDAC-2 or IDAC-4 data acquisition system.
This file will unpack into a directory with all required parts.
Before installation make sure your system is free of old SYNTECH software (including drivers and interfaces). This new version is ready for 64bit computer systems and is tested to work on Win7 and Win8. If you are in doubt don’t hesitate to contact us for support. If you need copies of older versions please contact us by email at firstname.lastname@example.org . Also if you need the TrackSphere software.
Here you find manuals and information brochures for most of our products.
Just choose from the list below. If you need any further information or help, don’t hesitate to contact us directly.
- AGILENT 6890 CG series (pin-connecti0ns of the signal-out receptacle)
- STIMULUS CONTROLLER CS-55
- Electroantennography (EAG) – (A comprehensive manual to perform EAG recordings)
- SYNTECH probes for EAG recording
- GC-EAD Effluent Conditioner Assembly
- HP 5890 GC ELECTROMETER
- 2-CHANNEL SIGNAL AQUISITION INTERFACE IDAC-2
- IDAC-4 Intelligent Data Acquisition Controller
- IDAC 4-CHANNEL FULLY PROGRAMMABLE SIGNAL AMPLIFIER
- INR-5 MICROMANIPULATOR ASSEMBLY
- TrackSphere LOCOMOTION COMPENSATOR Model LC-100
- TrackSphere LOCOMOTION COMPENSATOR Model LC-300
- SYNTECH Input PROBES for EAG and SSR recording
- ANTENNA SIGNAL SIMULATOR
- TASTEPROBE Type DTP-1 Pre-amplifier